FJ80 Auto Trans Throttle Cable Adjustment

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 26, 2009
Threads
3
Messages
21
Does anyone out there know how to adjust the throttle cable for the transmission? I have a A440F automatic transmission.

I just rebuilt it and now I cannot get it to shift throiugh the gears either manually or automatically. I have looked at all my possibilities and all I can come up with is maybe I did not adjust the cable properly.


Help!

Ed
 
The cable is the one with the red stopper on the throtle, IIRC its the botom one. There is a bracket with a nut on either side, they are 12mm. The little stopper on the cable should be .5-1.5mm from the rubber boot on the end of the cable.

Sounds more like your shifter linkage may not be attached to me.
 
Jeepcobra,
Thanks, But my cable does not have a stopper or at leasat one I can see. That is the point of concern. Is it under the boot? The cable runs through the housing and has an end on it. It is moiunted on either end in linkage. There is no way that this can be the red stopper.

As for the linkage i have looked at through and through. Both at the shifter and down at the trans and even inside the trans. It has park, reverse, nuetral, drive, and i can shift through the gears. It just will not shift hydrualically when it is under power.



Thanks Ed
 
I found the stopper it is a collet that can be crushed once the measurement is found. All of you mentioned one measurement and not the other measurement. That confused me. Anyway I made both measurements from throttle closed (0.5-1.2 mm) and open throttle (32-34 mm). I did get the trans to shift somewhat better. But after it heated up I could not get it to shift anymore. It seemed like it was stuck in overdrive with no lower gears for power. But I will check more on Monday. Sunday is Mothers day and I do not dare work on it until Monday or else.....LOL


Ed
 
Back
Top Bottom