SOLD FJ60 Spare carrier

[hyhpe]

Location

United States

it’s from a FJ60. 60.00 plus shipping Shipping will be a bitch.

 

[Living in the Past]

I had a 2000 100 series and it uses a stranded wire not a chain. Have an 80 series and remember it being beefier. 60 series I believe the winch is position so handle comes out towards the right side in the back. Used one of these on my M416 mounted backwards on the front and handle is offset to the left. Not from a late FJ45. Those have a bracket riveted on the ends. Possible from FJ55? Have one of those as well. Remember my FJ55 spare tire carrier is off a early one and don't mine having the two plates. Will be around my collection of spare tire carrier mid week. If I remember could measure width on my FJ62. Should be the same as a 60 series. FJ55 is not as wide.

 

[hyhpe]

I had a 2000 100 series and it uses a stranded wire not a chain. Have an 80 series and remember it being beefier. 60 series I believe the winch is position so handle comes out towards the right side in the back. Used one of these on my M416 mounted backwards on the front and handle is offset to the left. Not from a late FJ45. Those have a bracket riveted on the ends. Possible from FJ55? Have one of those as well. Remember my FJ55 spare tire carrier is off a early one and don't mine having the two plates. Will be around my collection of spare tire carrier mid week. If I remember could measure width on my FJ62. Should be the same as a 60 series. FJ55 is not as wide.

I’ll measure It tomorrow. Thanks.

 

[Living in the Past]

Looked at my FJ62. Crank handle would be pretty straight out the back. Inside to inside frame looks close to 42". I know the FJ55 is narrower. Close to 42" would say it's an FJ60. Just about perfect to use on a M416. Holes matches the front spring mount. Just added a washer to the back side of the front mount to even it up. Then just needed to drill two holes for front side of the tire carrier.

 

[hyhpe]