FJ45 Bed Parts

[miker]

Location

United States

I have some left over bed parts from my FJ45 Long bed pickup. These are:
-Center Floor
-Smaller floor pieces, one for each corner floor section of bed
-Wheel wells, driver side has outside lip cut off
-bed supports

This stuff is rusty with full rust through in small areas but a lot of it could be used for patching a bed. Some of the bed supports are still solid and could be reused. Some floor pieces have cracks or splits and a lot of holes where the spot welds were drilled out. Again, probably ok for patching a bed.

ALL PARTS HAVE BEEN "SOLD".

 

[friel01]

otehr stuff

Miker,
dont know if you have them, but I am looking for the j-hooks that hte tailgate latches too. Also could use a drivers side rear corner section, where the side panel bends 90 degrees to wrap around the rear sill. Got any of those?

 

[KT40]

I'd be interested in the floor pieces. If your coming to the swap meet on saturday,I will be there.Thanks,Ken

 

[miker]

Miker,
dont know if you have them, but I am looking for the j-hooks that hte tailgate latches too. Also could use a drivers side rear corner section, where the side panel bends 90 degrees to wrap around the rear sill. Got any of those?

Nope, don't have any of that stuff available.

 

[miker]

I'd be interested in the floor pieces. If your coming to the swap meet on saturday,I will be there.Thanks,Ken

I plan to be at the swap meet.

 

[KT40]

I plan to be at the swap meet.

Cool! Could you haul the stuff there?Are you looking for anything in particular?If not,Whats your drink of preference?

 

[D'Animal]

I think OrangeFJ45 aka Georg was looking for some stuff. The last time I was in his shop he had half a 45 bed that he was going to turn into a couch.