fj40 to 45 help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 18, 2006
Threads
2
Messages
3
Thanks to all for help on the leaky transfer case.
I want to convert my fj40 to a 45 and have read the threads on this. I have time, equipment, patience, (little $) but having read the threads, I am confused about how to proceed. I was going to extend the frame at the rear, move rear spring hanger and get 3/4 ton springs (or just use fj40 springs and move the whole spring/axle back) and move rear axle back, fabricate cab from remains of fj40 cab and make a box to suit. Threads mention inserting a piece into frame and then boxing around it instead of just lengthening it, adding cross members, moving front axle forward and/or reversing the front springs and a few other mods that make the job bigger. Is my plan ok, or is there trouble ahead if I don't make the mods in the way described in the threads.
Thanks for any insight or links.
 
I thought about doing this using an FJ60 Frame before I found a good tub and frame for my 40. What kind of condition is your 40 frame in? What treads are you referring to specifically? What are you skills like?
 
I'm working on a 40/45 hybrid right now.
My first thought was to hack the frame off behind the cab an link it, but didn't think this would work to well since I wanted to use the truck as a truck and haul stuff on ocassion.
Second option was to do as you were thinking, just extend the rear of the frame, and use longer springs. Didn't like how it looked on other rigs, and I wanted to keep the cruiser as factory looking as possible.
What I'm doing is splicing into the middle portion of the frame to extend the wheel base. This way I keep all the rear of the frame looking factory, like it was meant to be that way, and still gives me the room for a flatbed, or whatever craziness I plan on.
 
I too am currently working on a 40->45 project. I agree with RANGER, cut somewhere in the middle where the frame runs are level and splice in the required length to get the wheelbase you want. That is my plan at least. I want to keep the fj40 rear spring hangers in the stock configuration to keep that stock look and allow for use of original or aftermarket fj40 springs. Being that mine is a 79 the frame location for the oem rear cab mounts(used to be the 40 mounts near the middle of the tub) exist directly above the front mounts for the rear springs, so those will have to be cut off and refabricated closer to the front to accomodate the new frame length.
 
Back
Top Bottom