FJ 80 EGR Removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 27, 2006
Threads
77
Messages
1,152
Location
The Land of Frank Rizzo
Do you have to remove the studs to get the EGR off? The FSM tells you to remove them, I opted not to do that and now I am having a great deal of difficulty removing the EGR acorn nut - that's the one in the back.

Thanks for the help.

John
 
im interested to know as well. FSM says doublenut it to remove the stud, but there are barely enough threads to put a 2nd one on. the acorn nut...are you referring to the one that connects to the egr pipe? what size is that? i soaked the all the 3 nuts in penetrating lube...hopefully that will help when it comes time to do mine. not much room back there to get at it thats for sure.

why toyota didnt just put a standard bolt through there i dont know...
 
EGR Pipe acorn nut....Not much room - you're telling me - holy crap. Between the main engine wire harness and all the other crap that's back there, what appeared to be an hour long job is going into bonus time.

Penetrating fluid has been applied and now I am going to give it a second attempt at removal. I think if you take the studs out then you be able to rotated the EGR itself and that may help with the removal.

More to follow...
 
Can't get the studs out, I think I will put the bolts on and hit it with heat and then re-attack. I have been using a crescent wrench and taping it a 2.5lb sledge and since those bolts are off the valve is moving when I tap it, so we'll put the bolts back on and try again.
 
I could not get the EGR off without removing the two studs. They came out very easily using the proper, small, socket right on the stud. It was very simple and quick.
Chris
 
There's a specific type of socket that will remove the studs, or is it just a super small standard socket?
 
On my 97 it was one from my basic tool kit. Metric, 12 pt probably. Just look at the end of the stud and see if it looks like a socket will fit over it Your studs may differ??
1997 FSM (EC-14) says to use 2 nuts, but look at the stud in the pic (mine looks like that), the end accepted a socket, turned right out.

moz-screenshot.jpg


EDIT: Just checked, I used a 5mm, 6pt socket. However 3/16 is just smaller than 5mm and may fit.

Chris
EGR.webp
 
Last edited:
I will pull out those today and hopefully everything else will fall into place.
 
Removed the studs with a 5mm socket - that was easy.
Removed the heater hoses - that was easy as well
Applied a 1/4 can of PB Blaster
Applied heat for 5 minutes
Applied more PB Blaster
Turned nut the correct direction
Removed EGR :)
 
Something about righty-tighty - lefty-lucy, only in reverse.
 
Installed the new EGR today and things went a lot smoother. It took only about 30 minutes for the install and needless to say I am happy that this event is over. After 2 start cycles, the CEL has remained off, I hope that the Code 71 stays away forever.

One thing that I did notice is that the idle seems lower than normal, she idled about 650rpm and now its below the normal parameters, at the end of the test drive the seemed to return back to normal, is it supposed to do this?

John
 
Back
Top Bottom