Factory Subtank Repair

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 23, 2005
Threads
75
Messages
3,365
Location
Oregon
So I bought a '95 that came with the factory subtank w/ the filler neck with the pull knob. Anyhow, I was putting gas into it for the first time and it started dripping on the side where the filler neck is located. I didn't get a chance to see where it was actually dripping from. So, I'm going to be dropping this tank and see what I see. I'm wondering if there are any tricks to dropping it? Looks like it is held in with a couple of straps but I have no idea if there are other things to disconnect prior to undoing the straps?

Any help / advice would be helpful. New territory for me.
 
If it's dripping from the filler neck hose, you will probably not have to drop the tank. May just have to replace the hose or tighten the hose clamps. If you do need to drop the tank, it's pretty simple.

First, remove the filler hose from the filler neck and tank. Then, there's one electrical connector for the fuel level sender and a small hose to the fuel pick up tube that need to be disconnected. Then remove the two bolts on the hinged straps and it should drop right down.
 
Back
Top Bottom