Factory glass break sensor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 22, 2006
Threads
28
Messages
246
I just had my truck broken into for the 3rd time in 6 months today. The passenger side front window was broken. the previous 2 times it was the back glass and the little window on the driver side rear door.

All three times the alarm did not go off. The first time i adjusted the sensor up to maximum sensitivity. The 2nd time i did nothing because i figured it was to far back for the sensor to "sense". This time it just pisses me off to have to replace another window and vacum broken glass out of my truck.

So, do any of you have experience with the toyota alarm glass break sensor?
 
when my vehicle was broken into, i'm pretty sure it did not go off. I haven't actually adjusted it up yet. Is the adjustment box under the driver's seat btw?
 
Ditto, did the same thing here and was broken into with no alarm. Which is actually fine. Because now I can remove this useless pile of crap and put in something useful like kill switch.
 
Well, did they just break the glass or did they open the door too? Opening the door should have set off the alarm if the glass break sensor didn't. Sounds like there's a problem with the alarm just not working.

Does it lock the doors automaticly when you push the button and does the red light on the dash come on?

Also, I believe the Toyota alarms are equipped with a kill switch too, if the alarm goes off, you shouldn't be able to start the rig.
 
no, all times the f-n theives broke the glass and either crawled in or reached across and opened the sliding windows and crawled in. They did not open the doors and yes, I did check to see if it goes off when that happens.

anyone know of any quality aftermarket glass sensor alarms that can be used in conjunction with the oem one?
 
Well, it may be that the break sensor only works for the front windows. Not sure.

A trick I used for the rear sliders is putting a zip tie in each latch so that it makes it extremely difficult to unlatch. I also plan to put a coupler rod in between the two latches that will make it impossible to open either window from the outside.
 
The microphone works fine, but has its limitations. The OEM setting is pretty insensitive due to possible false alarm. In order for a glass detector to work properly, it will almost always trigger during a heavy rain storm.

The mircophone also needs to be near the window for it to hear the glass break. For some unknown reasons, Toyota puts it on the bottom of the instrument cluster. I opted to relocate it to the top center location at the dash.

attachment.php
 
Mine never went off......:idea:maybe I don't have one.....
no windshield 2.webp
 
I have my microphone in the top center. My front passenger window was opened, and the door wasn't.
 
When I put in my CDL switch, I moved the sensor to drivers side of the dash like it is shown in the sale brochures. I think it probably has to be close to the sound source for the mic part to work. Really all I have been concerned about is the kill switch works if the alrm goes off. Don't want my cruiser going anywhere without me.
 
Really all I have been concerned about is the kill switch works if the alrm goes off. Don't want my cruiser going anywhere without me.

From the TVSS installation manual

Starter Kill Operations Test:

1. Sit in the driver's seat with all doors and tailgate closed.
2. Arm the system with the remote control
3. Wait 2 seconds, then open a door. The system will trigger.
4. While the alarm is sounding, use the ignition key to try to start the engine. The starter should not crank the engine.
5. Disarm the system and start the engine to verify that the engine is working properly.
 
4b. Try to start the engine again and the security system override is activated and the vehicle starts.
 
Do all late 80s come with the RS3000 system? I just bought a fob and tried to program the alarm. Looked under the seat, nothing. I started to notice that I don't have the red light like everybody else seems to have. Mine is just a single light that can be pressed in and depressed and is missing the glass breakage mic. I can't find any toggle switch anywhere either. I found a box that was zip tied by the cruise control box under the dash. This box looks nothing like the RS3000 box pictured and has no button to program. What do I have?
 
Back
Top Bottom