F or 2F motor???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 7, 2006
Threads
31
Messages
274
Location
Maricopa, AZ
Hello everyone,
I've got this motor with this stamp mark. I don't have a clear view on the serial nubmers. I was hope someone might now the year and type???
93_0.jpg

it reads 11411
and 61010.

Thanks in advance!!!
 
Look by the starter motor....there is a rasied flat surface that is likely covered in grease/dirt....scrape it clean and your engine SN will be there...



Good luck!

-Steve
 
If you can see it, look here for a casting number. It will tell you the day the block was cast. Back by the block drain...on the driver's side.

Otherwise, as Poser said, the flat spot between starter and dipstick on the pass side will have a number beginning with either "F" or "2F"

The one pictured was cast on Dec 18, 1976



61218......year, month, day

GL

Ed
2F 016.webp
 
Degnol said:
If you can see it, look here for a casting number. It will tell you the day the block was cast. Back by the block drain...on the driver's side.

Otherwise, as Poser said, the flat spot between starter and dipstick on the pass side will have a number beginning with either "F" or "2F"

The one pictured was cast on Dec 18, 1976



61218......year, month, day

GL

Ed


so if his says 61010 then it is from 1976 oct 10, and therefore a 2f?
 
I think that is a casting number, the date-indicating casting number id back by the block coolant drain. Can't really tell, but the pic you posted seems to be farther forward on the block.

GL

ed
2F 001.webp
 
That appears to be the one.......vegetation and all:D

Good Eye!!!!!!


Appears to be cast on July 15 of 1975


Ed
 
thanks for all the help you guys!!!
didn't have the chance to talk my friend out of selling it.
Too bad!!!
thanks for the INFO.
nothing like some more FYI to add to the memory bank.
this forum KICKS ASS!!!:beer: botoms up to everyone.......
 
I liked the e-bay writeup:
This is a Toyota FJ40 engine that has been sitting in my yard. It is too heavy for my wife to throw out and she can't burn it, so I need to get rid of it before she throws me out. I know nothing about this engine, so do not ask! What you see is what you get! The starting bid is $1 and you have to pick it up! I have an engine crane to put it in your truck. The pictures have some casting numbers that may help you. Worst case, you can use it for an anchor for your boat or leave it in your neighbors driveway just for fun!
 
2F swap

Is the 2F a direct bolt-on replacement for the earlier F engine? Would current F intake and exhaust manifold fit on the 2F? Are there any considerations when making this swap?
 
Yes, it will bolt right up to a 3 speed or 4 speed bellhousing. The motor mounts are the same. You will have to enlarge the mounting holes on the intake and exhaust manifolds as the 2F uses larger studs. The oil pressure sender is on the pass side, so you'll have to extend that, too.

GL

Ed
 
Sweet

Awesome, thanks.
Now I just need to find a 2F near the SF Bay Area
 
Your '74 F head on a 2F would be killer. Save the head.;)

Ed
 
Back
Top Bottom