F engine, 2 valves sticking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 19, 2006
Threads
29
Messages
165
Location
Anderson, SC
I just bought this cruiser, hooked up a battery yesterday and it cranked over fine. No gas in it right now. I sprayed some starter fluid in the carb and it wanted to start. 2 of the valves, when pushed by the rocker arms, stayed to where they were pushed to. The engine has not run in 2.5-3 years. Is this a problem or can I unstick them easily soaking them in oil? Is it head rebuild time?
 
craptacular said:
...2 of the valves, when pushed by the rocker arms, stayed to where they were pushed to. . . . Is this a problem or can I unstick them easily soaking them in oil? Is it head rebuild time?
Yes, it's a problem. You may be able to "unstick" them, but a head with two stuck valves likely has a few other problems as well. (Gummed or corroded guides, bad return springs, corroded valve stems...) More power to you if you get it going this way.

I suspect you'll be happiest with a head rebuild. If you've got a strong back (or a friend with one) then pulling the head is no big deal. The machine work isn't outrageously expensive either.
 
craptacular said:
I just bought this cruiser, hooked up a battery yesterday and it cranked over fine. No gas in it right now. I sprayed some starter fluid in the carb and it wanted to start. 2 of the valves, when pushed by the rocker arms, stayed to where they were pushed to. The engine has not run in 2.5-3 years. Is this a problem or can I unstick them easily soaking them in oil? Is it head rebuild time?

try soaking in oil.

if this deosnt work and you dont want to pull the head, lever them up again, push them down, lever up etc (for a while) with oil.

If you can get them free enoguh to start it, 5 minutes running should loosen them up properly...
 
Chef said:
Marvel Mystery Oil has been recommended to me several times for this sort of thing, tho I've not actually tried it yet...

Marvel is some mix of solvent and transmission fluid I think and would help with stuck valves like that better than oil because of the solvent.

You need something that will get down the valve guides and ungum them, if the valves aren't actually bent. I'd probably give Liquid Wrench a try with plenty of repeated soakings.
 
I've had this happen because of running with really old gas. It was dumb to do it but I didn't have any way to get gas for it. I just used a rubber mallet and tapped the valve stems a few times to get them loose and working again. Cleaned the fuel system and everything worked fine.
 
I bought some marvel mystery oil and poured it on all of the valves. A new problem poped up. When the oil went down the head into the block, it started coming out of one of the bolt holes holding that cover on pass side of block. I found a bolt, but feels like something is broke off.
 
Welcome.


It is not too hard to think that someone broke one or more of the 6mm diameter, 10mm wrench bolts that hold the side cover on the bock...


Get it running if you can, otherwise you will have lots of time to concern yourself with that sidecover gasket while the head it off. ;)


Good luck!


-Steve
 
I have used Marvel in a couple of old engines for various reasons over the years. It seems to do a lot for valves and lifters. I'd use it in this case. Only costs a few bucks and won't take long to see if it is going to help.
 
Back
Top Bottom