Exhaust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 29, 2005
Threads
34
Messages
240
I picked up a con-fer tank at the valley swap meet yesterday. Great event for those of you in CA who missed it BTW. The question is knowing that with the tank installed getting the exhaust out the back is a trick. Has anyone ever considered running their exhaust through the frame? My thought is cutting a hole 1/2 to 3/4 larger than my pipe amd tubing it with thick wall pipe and plating both sides. This would allow for the pipe to pass through the frame rail and lay tight to the outside of the frame to the back.

Thoughts?
 
personaly i would not put a ~3in hole in my frame, reinforced or not.
the exaust on my 55 with 350 runs through the front spring, just in front of the fixed mount. my mufler is in the stock location on the drivers side and the coresponding location on the pasenger side, both dump just in front of the rear tire.
it worked great untill i used my glasspacks for rock sliders... now it leaks a little.
this might not work with shackle reversal.
good luck, carl
 
For a single exhuast with the muffler inside the frame rail behind the xfer skid plate, the tail pipe will slip just under the frame a few inches back from the rear spring's spring pin for a behind the tire side exit. The spring would have to endure some mega negativity to come close to hitting the tailpipe.
 
Hey Cammy, pleasure meeting you btw on Saturday. Do you have a body lift? Where are you located? There is a local muffler shop here in Rancho Cordova that does :grinpimp: work. Moreno's Mufflers. All show quality exhaust. Any given day you will see 2-4 classic show muscle cars in his shop. Just an fyi, for a nice clean/tight job.
Take care,
Campy

btw, I mistakenly sold that tank when I wasn't supposed to to Dan.:doh: However, I'll need to fab up a couple more for my other cruiser and maybe for others interested. Aluminum??:grinpimp:
 
Back
Top Bottom