Engine Swap

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 28, 2006
Threads
1
Messages
2
Good Evening Everyone,

I have a difficult question to ask. I have been a Jeep guy for years (Grand Wagoneers only) until I purchased my '69 FJ 40. The engine is a an F, but has been redone by the PO using caulk and banding to hold it together. A Ford carb and some garden hose later and the engine is not in the best shape. The engine I want is 6K and right now I do not have the $$ for a whole redo. I do however have a number of old Jeep engines, specifically a perfect running 1977 401 V-8, from the Quadra-Trac era.

Could I, has anyone ever done an engine swap like this? Is it even a possibility. Thanks for any guidance you can provide.
 
Welcome.


If you have the trans and tcase from the quadralosertrak jeep then it should be offset, similar to the Land Cruiser axles and could be made to work...
 
Thanks for your quick reply. Actually, I was thinking of modifying and using the entire drivetrain of the Jeep in the FJ and hoping for the best. I will be pulling the body apart for painting and making my measurements for the swap at that time and checking what my new sizing needs will are. Now the next question, is there anyone that may have done a similar swap?
 
I think that's worse than putting a ford engine into a chevy!!!! sell the jeep engines and buy the one you were looking at. or you can pick up a used 350 for around 500-1000 buckaroos.
 
i would stick to the cruiser stuff personaly, i think it would be stronger than jeep stuff. having said that, its a land cruiser and if you have the time and money you can do ANYTHING to it... just depends on how many hours you wanna wrench and curse and swear about the mod you have chosen...personally i would look for a chevy smallblock as its a fairly common conversion and there are a ton of tech articles about them...
 
Back
Top Bottom