Engine Ground Bolt(s)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 13, 2003
Threads
834
Messages
5,790
Location
North Front Range, CO
Where are they and how many of them?
Where in the FSM does it show engine ground bolt(s)?

I found two. One off the battery and one off the exhaust side of the motor from above the manifold to the firewall.

After I clean them, do I leave them dry or use dielectric grease on them?
 
Last edited:
The EWD (elec wiring diagram) manual specifies these. On my 97 there are 7 in the engine bay. 3 of these originate from the bottom of the coil, these will trace to the intake manifold, fender and front engine hanger. 1 each at the front left and right fender. 1 at the neg terminal battery. 1 on the firewall near the heater hoses (I think you found that one)

There are others inside the instrument panel as well....

I don't think diaelectic grease is necessary...IMHO

--don
 
The EWD (elec wiring diagram) manual specifies these. On my 97 there are 7 in the engine bay. 3 of these originate from the bottom of the coil, these will trace to the intake manifold, fender and front engine hanger. 1 each at the front left and right fender. 1 at the neg terminal battery. 1 on the firewall near the heater hoses (I think you found that one)

There are others inside the instrument panel as well....

I don't think diaelectic grease is necessary...IMHO

--don

Awesome! Thanks for that. I gotta get one of those EWD things! :cheers:
 
A little anti-corrosion grease won't hurt; like the ground on the left fender off the neg batt terminal. Mine was cruddy.

...
 
Don,

Because you live in fantastic cali you probably dont have corrosion issues - hence little need for dielectric grease. In places like colorado and pretty much anywhere in Canada, dielectric grease is somewhat useful. I put it in every electrical connecter I take apart that is potentially exposed to the elements. Two reasons: 1) makes for easy opening of the connector and 2) prevents corrosion.

Karl
 
I think I found most of them. Some were in need of cleaning.
After cleaning I coated them with NYK77 Corrosion Preventative Compound.
I also lubed up all the plug connectors I could find.
Non of them except a ground wire plug were corrode.
Thanks for the tip knorrena, the NYK also lubes the connectors so they remove and plug in easier.
They are a pain to remove when covered in Western CO clay/mud.
 
Don,

Because you live in fantastic cali you probably dont have corrosion issues - hence little need for dielectric grease. In places like colorado and pretty much anywhere in Canada, dielectric grease is somewhat useful. I put it in every electrical connecter I take apart that is potentially exposed to the elements. Two reasons: 1) makes for easy opening of the connector and 2) prevents corrosion.

Karl
Yes... sunny california is nice... I do get a lot of wear and tear occuring on my sun roof however ... oops .. gotta go, I'm late for my run on the beach... [-)

--don
 
Back
Top Bottom