Engin, engine#9

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 16, 2007
Threads
23
Messages
660
Location
Austin, TX
Engine, engine#9

Pulling a couple of 3FE"s,A440, x-fers in the 91 FJ80. What might I have missed that I couldn't see?
Please advise on angles when pulling them out.

The front is clear, electricals pulled thru the firewall, exhaust off, trans cooler, evap, other lines gone. Motor mounts and the supporting cast is all I think I have left, but wanted ask. I know I missed something. Can I get a check on this or that? All 3 are being removed together.

Shirley, there is something on top of the trans/fer I missed?

Thanks,
Matt
 
Last edited:
Tough crowd.

Does anybody have a couple of ideas, hints, or tricks that might be helpful? Both are 1991 80's. I'm renting a hoist tomorrow, any insight is greatly appreciated.
 
I think alot of people in this forum are not mechanically inclined enough to pull a complete motor,let alone the whole drivetrain. Most here have done the HG replacement and maintenance stuff. Very few have gone where your going. Good luck....
 
The only things I was wishing to know were the specifics to look out for when pulling all the drive out as a unit. I think I have them ready to go, on both vehicles. Is it maybe easier to raise the rear end, or jack the body up a tad, you know, those sort of things. I can't imagine I might have missed something, but maybe there was that "one" thing I overlooked.

This is my first rodeo:cheers:
 
Update,

They both came out fairly easily. I rented a $20 hoist, took the blown motor out one afternoon, and the good one the next morning. It doesn't take long to yank them out. The one thing I wil advise everyone is to have a lift while getting ready to pull. The crawling, twisting, and turning beat me up pretty good.

Another thing, when removing the shift lever for high/low, do drop the rear end a bit, take out the console, the dust cover, then the 4 12mm bolts on top, it's much easier that way.

I didn't have time to complete the entire swap, but this is a good thing. From the looks of it the #6 rod bearing, then cap let loose and the connecting rod knocked a hole in the block. The motor had 235K on it, the other has 210K, so I'll be changing the rod bearings before it goes in.

All in all, not to tough of a job. Maybe a 7 on a 10 scale.:D
 
Back
Top Bottom