elocker fork

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 2, 2007
Threads
373
Messages
4,438
Location
Longmont, CO
I have a rear elocker third that the salvage yard abused a bit and broke the fork that hold the locking collar. The fork itself was knocked out of alignment and then the end broke off.

I've removed the cover plate that holds the switch - this freed up the fork so it can rotate back into the proper position. It seems that the actuator rod itself can rotate - I just wanted to verify that its supposed to rotate like this and that the actuator isn't wrecked somehow. Anyone know.
 
The fork bolts to the the shaft, which would prevent it from rotating on the truck. But I don't recall if it should be rotate in the actuator not installed.
 
The fork bolts to the the shaft, which would prevent it from rotating on the truck. But I don't recall if it should be rotate in the actuator not installed.

Well, in the truck the fork and collar are around the axle, so the fork can't move anywhere.

However, when the third is out of the truck (no axle), the shaft that the fork bolts to rotates a bit (and thereby the fork too). I'm trying to determine if thats normal...
 
Sorry, it's been a couple year since I had mine out I just don't recall.
 
...
I've removed the cover plate that holds the switch - this freed up the fork so it can rotate back into the proper position. It seems that the actuator rod itself can rotate - I just wanted to verify that its supposed to rotate like this and that the actuator isn't wrecked somehow. Anyone know.

The gear teeth are cut all of the way around the shaft, so it's normal for the shaft to spin/rotate.
 
The gear teeth are cut all of the way around the shaft, so it's normal for the shaft to spin/rotate.

I got bored in the garage before checking this thread and popped the actuator open - yep, you're right!

I broke the o-ring in the process, I'm just going to silicone it - any comments?
 
...
I broke the o-ring in the process, I'm just going to silicone it - any comments?

As long as it's sealed, it's good to go, mine is sealed with silicone.
 
ok, I went to seal it up but I realized I removed the shaft so I lost the relative alignment of the switch wipers and the shaft.

Does anyone know where to "set" the shaft position at each limit (when the actuator is removed)?

That might be a lot to ask, so the same question in a different way - when the actuator and collar are installed, should the springs in the actuator be "wound up" when the collar is fully engaged, or does it engage the collar just enough to lock and then stop?
 
I think if I remeber correctly when the shaft is all the way in it measures something like 2 3/8" and then when it is in it's engaged position it measures 2 13/16" out from the actuator. You can't quote me on those numbers but it is near there. There is a post on here SOMEWHERE that has the exact measurment.
 
Back
Top Bottom