Electric Choke Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 11, 2006
Threads
111
Messages
474
Location
Houston, TX
I am the new owner of 70 FJ40 with original F engine. The carb, however has been changed out and has an electric choke. The choke is wired directly to the positive terminal of the coil. Is this right as it seems it would be hot all the time the ignition was on? If not how should it be wired? Also, is there an easy way to tell what kind of carb I have? There is a numbered tag, but no other markings I can find. Thanks
 
Welcome.



Carb could be anything....Weber, Holley, Motorcraft or ??? If you can, post up a couple pictures....Electric chokes are typically connected to a switched 12 volts, so that it is getting power when the key is in the on position....


Good luck!

-Steve
 
That is probably correct, most electric chokes use this hot wire to heat up the mechanizim inside, as it heats up the choke opens up
 
Back
Top Bottom