Egr replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 26, 2015
Threads
63
Messages
255
Location
las vegas
I just finally got my egr valve in the mail ... so today my protect was to replace it, not only was the tube coming out of the intake caked shut but almost all of my hoses were filled with rust or i don’t even know ....then as i was cleaning out the tube coming off the intake with a pick, the pick snapped off into it so then i tried using a magnet and pulling it out and couldn’t get it, sooooo guess what i did next, i had to push it into my motor ! That’s right ! So now i do not know if it will affect me
In the future butt my egr and hoses are now clean ... so o started her up and so far no problems wish me
The best of lucky !

3B740C1C-A212-41A6-90E8-F179C56CA43F.webp


0BBFEA26-BE7D-4101-988E-58D65C7CBBF5.webp


599E1218-FAA8-4088-80C7-77F13A9DDC26.webp


42B93847-AE69-4F99-BB67-62734A3F1EC6.webp


74678963-9FCF-4E78-89F2-6502563A1B90.webp
 
Unless I'm mistaken, this goes into the exhaust manifold. On the whole it would be better it wasn't there but if you have to have a bit of hardened steel floating around, better in the exhaust manifold than the intake!
 
If this is the one in question, it doesn't go into the manifold, it's simply a pass through, has another line on the other side to the VSV.
3B740C1C-A212-41A6-90E8-F179C56CA43F.webp

The harness clip is broken, allowing it to touch/rub on the hot EGR pipe, just asking for trouble. While the EGR was out was an opportunity to wrap it for additional insulation. At minimum, should be tied to the support peg, like this, preventing it from contacting the pipe.
Harness_zip_1.webp
 
Unless I'm mistaken, this goes into the exhaust manifold. On the whole it would be better it wasn't there but if you have to have a bit of hardened steel floating around, better in the exhaust manifold than the intake!
Still
If this is the one in question, it doesn't go into the manifold, it's simply a pass through, has another line on the other side to the VSV.
View attachment 1835559
The harness clip is broken, allowing it to touch/rub on the hot EGR pipe, just asking for trouble. While the EGR was out was an opportunity to wrap it for additional insulation. At minimum, should be tied to the support peg, like this, preventing it from contacting the pipe.
View attachment 1835563[/QUO damn your right i didn’t even notice that i will Fox it tonight ! thankyou
 
If this is the one in question, it doesn't go into the manifold, it's simply a pass through, has another line on the other side to the VSV.
View attachment 1835559
The harness clip is broken, allowing it to touch/rub on the hot EGR pipe, just asking for trouble. While the EGR was out was an opportunity to wrap it for additional insulation. At minimum, should be tied to the support peg, like this, preventing it from contacting the pipe.
View attachment 1835563
Did you ever blow a fusible link with that wire harness touching that EGR pipe? I may be having similar issues... Also where exactly is thid EGR pipe located on the FJ80?
 
Back
Top Bottom