ECM

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 15, 2006
Threads
83
Messages
803
Location
Ipswich, MA, North Dakota, Phoenix
Just got a call from the stealership - the intermittant cutting out on my '95 is due to a bad ECM, for certain, this time. $1700!!:confused: This, after replacing the EFI relay and coil. I haven't checked the harness for chafing as suggested by Dan, but will this afternoon. Will a bad ECM result inthe motor intermittantly stopping, then restarting after 20 or so minutes? Sounds fishy to me. Is harness chafing a big issue on FJZ's?
 
I would also suggest looking at the harness, but if you do have to replace the ecm, they are available used in the $250.00 range and it is a ten minute plug & play repair. Just make sure you aren't getting one from louisiana. try car-part.com
 
Harnesses don't chafe as much as they get brittle from the heat near the EGR valve. Not sure if this is the issue but it could be. When it dies does the started still work? Is it just not getting fuel when it dies?
 
Is harness chafing a big issue on FJZ's?

Damaged engine wiring harnesses due to the heat of the EGR is a big issue for some. The fix is to put a good heat insulating tape around the harness before it is damaged over time by the heat.

It is possible, though I have never heard of it happening, that a damaged wiring harness could take out the ECM. In essence, you could have 2 problems, the second (ECM) being caused by the first (short in harness.)

Before I put out $1,700 for a new ECM, I would want to be 100% certain that the problem was not something else and that the new ECM was not in jeopardy of being shorted like the old one.

-B-
 
Other than the '93 ECM problems that are documented and Toyota knows about, I don't think I have ever heard of anyone here on 'Mud "fixing" a problem with a new ECM.

-B-
 
I had a similiar issue on my 94, the mechanic suspected ECM or bad wiring harness, I called the stealership and got the quote of the year of the replacement ECM. I did some research and there's an outfit Florida called ECU Direct. They will dyno your ECM and if it's shot they can repair it $299. If they can't fix it then it's $499 for a refurb. Beware going to sight unseen Junk Yards. The problem here is that you don't know where, how what condition that car it came out of, ie front windshield missing for 4 years and you new ECM is now sponge, make sure they have some type of policy on returns.
The mechanic got out his multimeter and ohmed the wires. He found 1 bad wire going to the ECM. He installed his own wire and fixed the problem.
Hope this helps.

94 FJZ80 - not locked but Loaded for Bear
 
Back
Top Bottom