e-locker wiring question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 19, 2005
Threads
19
Messages
81
I am swapping e-locked axels into my non-locked 94 fj80. I got all the wiring I need out of the other cruiser. I have the harness that goes from the driver side kick panel the the back quarter. My question is how to remove the wires from the old plugs and insert them into the plugs that are in my cruiser.. Is there some kind of special tool to take them out? Any tricks I need to know? Any help would be apreciated. Thanks.
 
Depends on the type of connector. Some have a lock piece that must come out first. Usally it's a ribbed piece on the side of connector. Sometimes it's a white colored ribbed piece on the terminals of the connector. Sometimes it's not there but either way if it is or not, after it is removed there is still a tab that must be released down next to the pin in the connector.
 
I managed to get one wire out of the old plug, but I cant seem to get it to go into the plug in my cruiser. It goes in about half way then stops. getting the wire out was also a chore.. I dont think I am doing it right or using the right tools.. I try pulling that little tab backbut it doesn't seem to help much. do you have any pictures of the lock piece you are talking about?
 
all my electrical connector experience, read limited, has proved that yes you need the right tool to remove wires and it is a snap. Most connectors I've used have required pics, dental size approx, and that was it. That is my limited help.
 
If you can post pictures of the wire that you are working on that would give us what tools you need to get the job done. I used the smallest jeweler's screwdriver in removing the wire from the connector/wiring harness.
 
I figured it out. Took the "dental tool" and pulled gack the little tab inside the plug that holds the wire in. Some came out really slick and went in really slick, but a couple of them were a pain and I had to take a small pair of needlenose pliers and pull the wire through because it would not go in and "click". But I got all 5 wires in and sure enough the locker works like a charm.. Thanks for the help guys. IH8MUD rules!!
 
Back
Top Bottom