driving with P0305

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 26, 2013
Threads
14
Messages
104
Location
DFW, TX
Just started getting this issue as of Monday morning. Sunday, 12 hours earlier it was fine. I am starting to troubleshoot this. As of today I replaced all the plugs, wires, dist. cap and rotor. The issue came back unfortunately. Next I was going to look around the EGR, wiring, etc. as seems some others have had issues with this area (oddly enough I got an EGR CEL about 2 years ago for about a month, but it went away and never came back). So if anyone has any other suggestions I am all ears. I am not a good mechanic so I am slow when it comes to fixing.

So my main question is does anyone suggest not driving this back and forth to work every day until I get it ironed out? I have about a 35 mile commute every day, round trip. Right now my 80 is my daily driver, but I told myself if it started having any serious issue I may just find a car again.
 
The wiring next to the EGR would be the next place to inspect since you already replaced everything else. Sometimes just moving the wiring a little bit will either cause the issue to become more prevalent or go away. if that's the case, than the wiring is the issue. If there's no change in the misfire with the wiring, then it could be the injector.
 
So it appears my wiring is ok, but I am going to re-wrap it anyway since it is not covered well at the end (it is a bit of a pain to get too though). I think I may look at the injector next, but I don't like to rush things I have never done and I may just start doing a general engine overhaul since I haven't done much in the three years I've had it. I supposed the gravy train of no payment is over for, went ahead and got a new car anyway since I need some piece of mind for commuting. 314K miles I guess it is not meant to be a long-term daily driver without some more attention. Thanks again for the comments, suggestions, and messages from all.
 
I would not recommend driving with that code. You could potentially ruin your catalytic converter, or run too lean and melt a piston, or have detonation, etc. Excess vibration could ruin an engine mount too. I don't know if you could possibly disconnect the injector and the plug to cylinder 5, but I don't recommend driving it in this condition. Nothing good can come of it at all.
 
Back
Top Bottom