Driveshafts greasing question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 28, 2005
Threads
20
Messages
93
Location
Down under. Melbourne.
Just wondering what is consensus about how much they need to be greased? Way too much is definitely not good because it push out rubber seals. What I have heard (actually I personally disagree) that they have to be greased incredibly little. Explanation was – if put little bit more grease then when a shaft get compressed (axle going up) there is no way to grease to go and effectively shaft became “uncompressible” thus leading to shaft or even TC damage on big bumps. Any sense here?
 
Yes. That is true. If you over grease the shaft and fill the empty space with grease, when you try to compress the shaft the energy will transfer to whatever the shaft is connected to. This is especially harmfull if the vehicle is on a lift when the gap is filled with grease. If it were possible to completely compress the shaft I think you could pump till the cows came home with no ill effects. I don't think it's a crucial seal that need not be breached.
 
The splines of the driveshaft should be greased by taking it apart, and greasing the splines. Pumping more grease into the bottom of the well is a mistake and can cause t-case damage.

The spiders, on the other hand, can be greased until the cows come home. Other than the mess that is. I have heard of a theoretical concern with air powered grease guns messing up the seal, but this is definitely not a problem with the hand grease guns most of us use.
 
Back
Top Bottom