Driveshaft Rotational Play

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 19, 2014
Threads
18
Messages
485
Was under the 80 today to check the condition of the ujoints and noticed that both driveshafts have some rotational play. With the tcase in neutral I could rotate the driveshafts roughly 10 degrees (a mark on the outside of the pinion flange would move roughly 1-2cm) before I could feel it start to move things in the 3rd/axle. Was the same for both the front and rear driveshafts and there was no other play in the drive shafts.

Is this a normal amount of play for the driveshafts/3rds/axles?
 
From my experience that is normal. I had a driveline "clunk" and was getting about 45 degrees of play, which turned out to be the drive flanges. When I replaced them, I still had some rotational play.

Another way to look at it is that the FSM does not state an acceptable limit of rotational play; thus any amount is normal.
 
Back
Top Bottom