Driveshaft Powdercoating

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 21, 2004
Threads
20
Messages
149
Has anyone had experience with having their driveshafts powdercoated? My main concern relates to having the rotational balance disturbed. As I see it, if the coating were to be applied evenly, the balance would remain true. Whether or not this remains true in actual practice is something of which I am unsure. I am not as concerned with my front or PTO drive shafts as they see limited use when compared to the rear and, in the case of the PTO, is a slow-speed shaft. Moreover, because of its relative short length, the front does not concern me as much as the significantly longer rear shaft of my pickup which sees constant, high-speed use. I just wanted to post and see if anyone else has relevent thoughts or experiences to share.

Many thanks and a happy weekend to all.
 
My driveshafts are hand-painted with POR-15, which is thicker and heavier (and likely less evenly applied) than powdercoating. No problems. Rattlecan black over the POR-15.

The mass of the coating is so much less than the mass of the driveshaft, I find it unlikely that there will be a problem.

I'd recommend POR-15 over powdercoating.

Kirk
 
Back
Top Bottom