Driveshaft orientation

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 25, 2007
Threads
67
Messages
591
Location
Winter Park, CO.
If I am removing the driveshaft to replace the spider bearings, and also have them balanced, is it still important to match mark the diff/t-case mounts and the yokes on the shafts for orientation? Or is that unnecessary with the work that is being done on them?
 
my experince with this is that you don't have to worry about matching the shafts back to the original location. One thing you may want to consider is telling the shop to keep the shafts out of phase. The shafts come (out of phase) from the factory and if you don't tell the shop in advanced they will return it to you in-phase. Now for some this has worked but most people here will agree that keeping shaft out of phase is recommended.

-Juan
 
It probably isn't important to match the orientation of the driveshaft to the t-case or diff in any case. The drive shaft is balanced independently. It never hurts to put them back in the way they came out though, so if it makes you feel better, mark 'em.
 
A slight correction to what Sanchez said: the front shaft is out of phase and the rear shaft is in phase. Also, when you go to bolt them back up to the truck, mount them both with the slip joints closer to the front. This keeps the rear slip joint out of the rocks and allows the front one to clear the swaybar (and it's the way Mr. T did it!)
 
Great! Thanks for the info.

EDIT: Now, if I could only get those damn bolts and nuts off! Those things are really on there! I've tried some PB blaster, but no luck yet.
 
Great! Thanks for the info.

EDIT: Now, if I could only get those damn bolts and nuts off! Those things are really on there! I've tried some PB blaster, but no luck yet.

The transfer case flanges have pressed-in studs, so you loosen the nuts and remove the washers. The differential flanges are different in that you hold the nuts (diff side) and loosen the bolts (driveshaft side, with washers). It is tight under there though! If you are on level ground you can set the parking brake and chock a couple wheels, then pop the transfer into neutral to give you some slack in the driveline.
 
Back
Top Bottom