driveshaft.. is this correct?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 1, 2006
Threads
24
Messages
106
Location
Brunei
hi all,


i found there was flop in my front drive shaft.. i've tried greasing it but nothing happens. i checked the spider bearings for flop and everything is still good.

then i found that the part in the picture is hollow, is this correct?

b coz i looked at the rear shaft and saw that what looks like a seal at the end keeps the grease from coming out at that side..


btw, my rigs a 1980 fj40 everything stock except for a 2 inch lift...

thanks
IMG_0860.webp
IMG_0865 2.webp
 
No.


There is supposed to be a 'frost plug' of sorts to prevent dirt from mixing with the grease...


If the splines are worn on the piece pictured and the male piece on the drive shaft tube, I would find a new/used front shaft assembly and replace the front shaft assembly currently in your truck with it.


Good luck!


-Steve
 
roddie1154 said:
btw, my rigs a 1980 fj40 everything stock except for a 2 inch lift...

thanks

If that's your drive shaft it isn't stock. That is an early driveshaft, pre '74. That particular bit is very nice to have if you do an SM420/3 speed conversion. Curious as to the background here-is that your current driveshaft, and how stock is your FJ40?
 
yup it is my current driveshaft.. maybe the p.o changed the shaft before?

my 40 is stock as in very very stock:grinpimp: , original 2f, 4 speed....

poser thanks for the info.. i'll try to put in a water plug or sumthing..
 
roddie1154 said:
poser thanks for the info.. i'll try to put in a water plug or sumthing..

If you've got 'flop' it's because the splines are already worn - a plug is too late to fix that - as suggested get another d/shaft.

You should also check shaft length - if the shaft is too long the plug can get forced out when suspension is on full droop.
 
Back
Top Bottom