driven insane from belt sqeaking!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

nat

Joined
Sep 20, 2005
Threads
169
Messages
1,990
Location
Los Gatos, California
My SBC 350 alternator/water pump/crankshaft pulley belt is always chirping. Belt dressing, which I hate only temporarily fixes it. The alignment is off a little, but not too bad. I thought an idler pulley might help, so I bought one, fabricated a bracket and installed it. Now it does not squeak at idle, but does at speed. I know I must sound and look like a derelict going down the road. Anyone have any suggestions? I was going to hit the pulley with some sandpaper maybe.

Thanks
 
Chirp is caused by belt slippage.

Fix the alignment, then, if it is still chirping, look at how much wrap each pulley has.

Assuming you have a good belt of the correct width, and the tension is close to correct, chirping means you don't have enough wrap around one (or more) of the pulleys.

FWIW

Kirk
 
What have people been paying for junkyard parts to convert to serpentine belts, I've heard that you need the newer waterpump, but can the pulley just be changed on the alternator? the reason I asked is I just put a new alternator on, and have no other accessories, so is it worth it to change before I put on the power steering pump?
 
Back
Top Bottom