Door Actuator Installation/Replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 13, 2011
Threads
16
Messages
42
Location
OKC, OK
Hey guys! New here to the forum and to the FJ80 world. Purchased a 96 Lexus LX450 about a month and a half ago and have started down the same paths that all of you have been down of fixing the miscellaneous problems. My issue is I have identified that my actuators are bad on both back doors. I watched a couple of video's online on how to get to the actuator and test the motor, etc. I will be getting just the actuator part and not the whole assembly, but my question is how do you connect the new part to the lock assembly. It looks to be riveted, I need advice.

Dane ;)
 
Actuator...? Do you mean,,,regulator assembly. I'm not an expert by any means but how did come to the conclusion your regulator assembly is stuffed?
 
I went into the door and pulled the actuator. I opened it up and cleaned up and lubed the gear and motor. I plugged it back in and the motor tuned fine upon locking and unlocking. However, the connection to the lock hardware is very loose. And even though the actuator fires when the power lock is pressed, the link to the lock is not locking or unlocking door.
 
There are no rivets, just screws to get the actuator out. Some have had luck opening the actuator up changing the motor, most just buy a replacement. Did you hook it all back up correctly with the metal bars and plastic bits?
 
Back
Top Bottom