Dome Light

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 25, 2005
Threads
19
Messages
84
Location
Cave Creek AZ
So, here in Cave Creek, Arizona, it rained for the first time in about four months. Me and my buddies celebrated by getting my 80 filthy through some rather large puddles. There was an empty lot in the middle of the desert, and we decided to do some donuts :D. Strangely though the dome light in the back seat kept flickering on and off, until i stopped doing the donuts. Can anyone tell me why it would do this?
 
body flex.
 
I really doubt the connector has worked its way loose even after a gazillion years.

I'd check the ground or the bulb, which could have worked its way loose. I think the ground is internal and is in the dome light itself. So as long as the domelight is in there solid, it should be grounded. If this is the case then the two wires going to the domelight are for +12 and door ajar.

Riding around with the domelight off as usual, the door ajar line should be 0 V and the other line +12 V. You can test this with a DMM while your buddy does donuts in your 80.
 
There was an empty lot in the middle of the desert, and we decided to do some donuts :D.

No help on the dome light above what has been suggested but I would suggest you be careful about the donut driving ;p

A recent thread is on here about a kid, his friends, and his Cruiser that they rolled doing donuts/drifting. Hard not to play in the mud, just be careful to not become part of the "Turtle Club" :eek:
 
Last edited:
My door switch on the pasenger side was out of adjustment a little bit. When I would get strong Illinois cross winds (50 MPH) the lights would flicker. I added a rubber cabinet door bumper (per mud suggestion) that was about 1/8" thick and the problem went away.
 
I'll try the rubber cabinet door bumper, its not a serious problem by any means, I just thought it was a bit strange.

Thanks for your help!
 
here's a better solution IMO

My door switch on the pasenger side was out of adjustment a little bit. When I would get strong Illinois cross winds (50 MPH) the lights would flicker. I added a rubber cabinet door bumper (per mud suggestion) that was about 1/8" thick and the problem went away.

i tried the rubber sticky cabinet bumper thing and it fell off.
better solution is to lean on each door inside and see which switch is the culprit. pull up the rubber cover and unbolt the 10mm bolt and put an extra washer behind it. boom. switch is now out a little further and makes better contact with the door....:idea:
 
When I'm sitting in my truck with doors closed and the interior lights are on and dash illuminated door ajar symbol is lit I can just smack the bottom driverside door and it will go off. Smack it again it might come back on might not. I'm pretty sure it's the driverside door that's the culprit but other things have me wondering. While still sitting in the driverside and reaching across and opening and slamming passenger door does the same thing as smacking the bottom of the driverside door. Probably jars the switch on driverside. My question is what is this probably caused from? Switch? What kind? Where is it located? Do I need to order a part for permanent fix? Why does it do this more when its cold outside?
 
It could also be a loose switch on the upper tailgate, depending on which dome light was coming on. I recall reading about someone having this same problem, iirc. I think there are some contacts or something up there that can get dirty / corroded. :confused: Lemme go look at my truck real quick.
 
Well I have two answers. Sometimes both and Sometimes just the middle. I thought the flickering caused the rear bulb to blow until one day it came back on and started flickering again. But dash door ajar light always flickers with dome lights middle and rear.
 
Open a door and play with the "switch" a little to see if you can isolate the problem to a particular switch. Try all of them individually. On my LX the DS rear door switch is starting to get a little flaky in that the overhead passenger light sometimes comes on and sometimes it doesn't when the door is opened. Maybe this picture will help...

.
Door Courtesy Switches.webp
 
The way it seems is that I have two problems. First is I think the rear cargo light has a shortage because I just went outside and played with the doors and it wouldn't turn on even if I switched it to the on position. This light was working yesterday after being off for about a week.
Second is a door switch is probably also bad because dash door ajar button flickers on when the middle and rear cargo light flicker on (when ever the rear decides it wants to work that is) and all doors and rear latch are shut. ---------------------------Do I need to take the door panels off to get to the switch? If so is there a tool that will make this easy?
 
normal operation for donut detection circuit. If you were really puxhing it the light would have come on and stayed on....Other than that I'm going with door switch
 
Do I need to take the door panels off to get to the switch? If so is there a tool that will make this easy?

Nope...open a door and you should see the switch on the body of the 80, not the door. They should be in the approximate position shown in the picture above (at least on my '97s that is where they are).
 
Thanks Corsair23, I went back out gave another look and there they were. If it had been a snake.....
The picture makes it look like they were inside the door or atleast on the door. Confusing:doh:
 
The picture makes it look like they were inside the door or atleast on the door. Confusing:doh:

I agree...

Now that you've found the switches hopefully you can determine which one(s) are causing the problem(s) and get it resolved. I know I've read some threads of people putting washers (IIRC) between the switch and the body of the rig to space the switches away from the body more so they make better contact.

I have yet to actually take one apart so I can't really help you much on the R&R aspect. There isn't really a whole lot in the FSM about the door switches but they do look like they should be relatively easy to replace. I can't imagine they are all that expensive should you need to replace one. If you don't have a good discount with your local Toyota dealer then check with Cruiserdan here on MUD re: pricing for the switches.
 
Back
Top Bottom