Does this engine seem weepy to you?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2003
Threads
147
Messages
2,610
Lifted the hood to swap in replacement silverstar ultras when I spotted this ...

Is this excessive? I've been running rotella T synthetic for almost a year. Beyond that, engine is stock.

Sub-question: What is the most intelligent approach to cleaning this engine?
IMG_9384.webp
IMG_9388.webp
 
2 more..uploaded finally
IMG_9394.webp
IMG_9401.webp
 
Last edited:
If it doesn't make a puddle on the floor, why worry? :D

You just need a new valve cover and spark plug gasket kit from Cdan. You are 2 hours away from sparkly shiny. I run the Mobil 1 HIgh Mileage, it seems to help with the other gaskets that are not so easy to fix.

For cleaning, warm engine up, shut off, wrap distributor with foil, spray on degreaser of choice, wait, hose gently, avoiding spark plug boots and wiring connectors.

I did this once about 4 years ago, I think.....
 
Either your valve cover is lose or you need a new gasket (looks to me like you need a gasket) You can try the bolts to see that they are tight.

Foam engine cleaner on a warm (not hot) engine and a small brush with a weak stream from the hose to rinse will clean that up.
 
If it doesn't make a puddle on the floor, why worry? :D

I'm in a preventative frame of mind. :) Nothing on the floor though...

Either your valve cover is lose or you need a new gasket (looks to me like you need a gasket) You can try the bolts to see that they are tight.

I blasted through the bush a few days ago and coated the engine with mud. The things never been cleaned, but maybe it's the contrast of the oil against the grey mud that has me wondering. The fact that it jumped out as different has me thinking though.

Thanks for the cleaning suggestions. Cleaning is only meant to provide a new baseline as to oil leakage.


TY
 
i take a bottle of formula 88 degreaser(home depot black bottle white lettering) enviromentaly safe, drive to the car wash after hours and spray the engine and front axel down let it sit for a couple mins and pressure wash with soap and hot water, then re apply degreaser and spray it off again. The stuff works period. I dont cover anything, spray the whole engine compartment including bottom of hood, cranked up, belt squeals for a few mins and drive it home. Done:beer:
 
Get some Castoroil Super Clean and a squirt bottle. On a cold engine, cover the dist. cap with a baggie, spray the cleaner all over, crawl around under the truck and see what you can spray down there. Let it soak for around 15 minutes and blast it off with the hose. The stuff works better than gunk or any of the others that I've tried. If you've got a lot of mud, you can even pre-soak with plain water to "soften" it up a bit before spraying on the cleaner. And you're absolutely correct, cleaning it is the only way that you'll find out where the oil is leaking from for sure.
 
I thought that was Canadian rust prevention?
 
Heck,.. mine looks like that and it has 310k on it... no leaks or anything... I'm not even concerned about getting gaskets for the VC or anything.
 
Back
Top Bottom