Do I need this after desmog? Getting things fixed.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 30, 2015
Threads
95
Messages
571
Location
Houston, TX
Do I need to keep any of the “vacuum” box on the fender after I remover the rail and air pump? I keep getting a feeling of a rev limiter under load. Thanks.
03BA7770-5D86-497A-8C2E-9697833D887D.webp
 
Well, you can run manifold vac straight to the choke breaker, and manifold vac to the air horn (power valve). I don't know if it is the same as the original configuration, or just a warm sentiment.

The VSV is a great component for venting the charcoal canister, but good luck finding consensus on the issue. I don't know if you can use just part of the VSV, or not.
 
Dizzy, just trying to make sense of what I have. No choke break or power valve right now. Temp carb on while other is rebuilt. Those two do run thru the box have plugged now. I am getting a hesitation under load as rom range increases. Trying to track down.
 
I think that most carbs have a power valve, just with vac routed internally. My electric Weber has a choke break too.

I'd consider spark timing and dwell for issues at higher rpms. I don't think that that VSV does any harm, if you have it not connected to the stock carb, or stock distributor. You can plug all vac routing, and figure out the gas tank later.
 
I am thinking a lean issue or spark. There is a HEI on there, not any vac advance, centrifugal so may be weights. Again, just dealing with what I got now. PO install. Thanks @Dizzy
 
Right now a move non US spec. Should have the Original done and back on in a few days. May just wait until then to dial it in.
 
I really don't like my USA '75 carb, because gas, from the accelerator pump orifice, finds its way down the capped EGR inlet tube and rots in place, or gets hung up on the shelf that bolts in the primary nozzle. I know that most Mudders insist on the stock carb, or non-US-spec Aisan carb, but I'd like the fuel to actually make it in to the intake, so I get hesitation at acceleration that the engine doesn't experience with the Weber, but that is a different story.
 
So, solved the stumble. Applied constant manifold vac to the power valve and TP (choke break). Saw an old thread on a ‘76 desmog and JimC, @FJ40Jim says he turns that to a vac port I think when he rebuilds for desmog on the earlier carbs. Or apply manifold pressure to the paper value, to keep closed, and the TP if not rebuilt.
Still have an issue with the secondary not opening. Did the paper clip test. I am thinking I should plug the ported vac by the idle mixture screw since I don’t have a vac distributor. I may be losing vac there that port as I am still running to the VSV and I still need to figure out what to do with all of those ports.
 
Back
Top Bottom