FWIW, all you need is an h42 output shaft, some spacers, the washer and nut, an oven, a big welder, and some skillz
"DIY" hd mcnamara gear
- Thread starter orangefj45
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
well, and a gear or two...10% perspiration, 90% inspiration
it's only steel...
it's only steel...
How truewell, and a gear or two...10% perspiration, 90% inspiration
Niice! I might try this out, have all the spare parts needed, but not a lathe.
I'll write my own disclaimer
I'll write my own disclaimer
This just got interesting again...
I knew I had seen this thread before!
SLOP!
I knew I had seen this thread before!
SLOP!