distributor problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 5, 2010
Threads
4
Messages
20
Location
corryton tn
i posted up a week or so ago that i am new to the lc world. the 75 that i bought had been sittin 10+ yrs. when i got it home i checked fluids and etc, and got it to start one time. (just a couple of chugs) well after that it wouldnt hit a lick. so i checked for spark and nuthin. so i check the coil and it was good. so i figured the points to be the culprit. checked locally and no-one had them. so i ordered the PerTronix kit for the lc. finally got it 2day ( i looked like a kid at christmas) went to put it in, and it doesnt come close to fitting :mad: i did some searching around here, and it looks like the po installed a gm distributor? its model # 1112403 serial # f8 and the only thing i found on the forum, was saying it was junk. any opinions on what to do now? run it? throw it? as usual, any help/advice is appreciated
 
here is a pic of the distributor
1014101652.webp
 
Yank that dizzy out and put in the stock one and install your pertronix and you will be a happy man.


X 3 pull on pulling the GM distribitor It out as fast as you can.
Somebody said to Through Rocks at It, I'd then set It ON FIRE ! and then dance around IT :lol:
 
I think your 78 is all electronic anyway. There wouldn't be a need for Pertronix.
 
thanks guys. i appreciate the help on this. i am going to listen to u guys and throw the gm unit out. i just wanted to make sure there is no major issues with the engine. i did get it running last nite. i cleaned up the old points and cleaned the terminal coming off the distributor going to the coil, and i finally got spark. consistant spark. so i threw the fuel to it and she cranked up. :) a big relief. so now the plans are to tear it down to the frame to be stripped and powdercoated and do a resto-mod(2.5 lift, power steering, and disk brakes) been spraying all the bolts and nuts with wd40 for over a week now, hopefully won't be too bad for the tear down ;)
 
WD40 isn't the best penetrating oil, PB Blaster seems to work better IMO. Some have reported Kroil to be the best, but I have never used that. Prepare for broken bolts....and have a good time with the restore!
 
Ditto on pb blaster and impact wrench.
Also...I'm a big fan of heat and mapp gas is a cheap and compact way to get it.
 
i agree with the wd40 comment, but its all i had at the time. busted knuckles?, im used to that, and used to snapping bolts off. my other project is a 49 chevy 5 window pickup, plenty of dealing with rust on it. so is my 75 lc suppose to have a vacume advance or retard distributor? a member on the board offered a good deal on one that is thought to be vacume retard. and again, thanks for all the help. i cant wait to get the lc going.
 
Back
Top Bottom