Discharge weight removal???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 24, 2005
Threads
33
Messages
224
Location
Boonsboro, Maryland
Rebuilding my carb and need to know how do you go about removing the stopper and discharge weight to get to the BB at the bottom. Looks like it is riveted in or something. Don't want to break something. Thanks
 
Just did this last week.
After you remove the small gasket on top of the "rivet". soak it in PB Blaster or equivalent for a while. Then, invert the carb and tap gently on the body to dislodge. Do this over a work surface so you can catch the pieces when they fall out. You can also try to get the tip of an exacto knife alongside the aluminum rivet to pry it out.
Alternatively, you can apply air pressure to the port in the chamber and blow the pieces out, but I imagine that trick will scatter the pieces unless you have a strategy for containing them.
It WILL come out the other way, trust me.
 
My gasket was, and should be, a small washer shaped doodah, which was easy to lift out of the carb body. It sits level with the flange in the carb.
That exposes the aluminum rivit (stopper) which sits on top of the weight (pump discharge weight) , which sits on the larger of the two balls in the carb.
 
Back
Top Bottom