Disc Brake Conversion

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 31, 2006
Threads
3
Messages
3
I just picked up a 79 FJ40 chassis with complete orig, disc brake axle. I have a 69 with drums. What is the easiest/best way to do the swap? My research tells me (without actually checking the 79 members gear ratio) the 79 came stock from factory with 3.73s vs. the 69 with 4.11s. Any suggestions...Thanks Dave.
 
The easiest way is just to swap the knuckles out onto the '74. You will have to do a trivial amount of grinding inside the bell fo the axle to make the birfs slide in.

The '79 knuckles, birfs, hubs and steering arms are a good score.
 
What Drew said, plus, should be the same as a mini conversion. You can pick up info on that in the tech section...
 
Is there any reason why the entire 79 axle (except differential) couldn't be swapped in place of the 68 axle?

It would work fine, it would just be more work. You have to tear down the knuckles anyway-in one case to swap them into the 74 and in the other case, to remove the diff from the 79. Swapping the 79 knuckles into the 74 avoids messing with the diff, the U-bolts. spring pins, shackles etc. Roughly 1/2 as much work.
 
Hi All:

Also, if you swap the '79 axle assembly in completely, you will need to deal with the fact that the front brake light drops down on the "wrong" side for your '68. I dealt with this issue on my '74 FJ40 when I swapped-in a '78 BJ40 frontend by swapping over the original '74 front brake hardline (the line that runs across the top of the axle tube.

Good luck with the project!

Regards,

Alan
 
Back
Top Bottom