Disabling factory alarm

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 1, 2006
Threads
126
Messages
859
Ok now that I have an aftermarket alarm I HATE my factory one. If I leave a door open for just like 10 seconds it freaks out. How do I disable it completely? I tried pulling the fuse but that disables the horn as well. Any other options?
 
How is it freaking out? How did you install the aftermarket alarms without using the factory alarm wiring?


It can be deleted I don't remember the specifics but you basically remove the box and the harness from under the seat to the left kick panel, you don’t have to pull up the whole carpet just lift up the edge, at the door after removing the sill/kick panel

Only other thing is the starter kill solenoid, I cannot remember if you can just plug in two connectors after you pull the harness or if some jumper would be required.

The alarm in your LX450 is the same as the RS3000 in the Land Cruiser but in the LX has dedicated plugs in the factory wiring instead of being spliced in after like the LC.
 
Check the RS3000 manual, you can disable the 10 secomd alarm thing. I think Slee has a link to the manual.
 
Back
Top Bottom