Diff lock switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
101
Messages
513
Location
Alpharetta GA
Installed the center diff lock switch yesterday but the connector seems way too big to fit into the new switch. It was wrapped in foam right above the hvac controls like the instructions said, should I be looking for another connector?:confused: Everything else was super straightforward and did the cup holder at the same time, but there is no way the connector I found is going to fit into the switch. Ordered it from Slee for my 97 model. Ideas??
 
Here is a picture of what it will look like with the cap pulled off.
diff lock (Small) (Small).webp
 
Tommy, I did the same thing a couple of weeks ago. I tried like crazy to get the jumper wire out - couldn't (shouldn't anyway). Cdan enlightened me. The white thing you're looking at that is too big for the new switch gets removed. Good luck.
 
Back
Top Bottom