Diff Bearings

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
101
Messages
513
Location
Alpharetta GA
Well finally pinpointed my other noise. I can hear a roaring noise from center chunk of rear end with my cruiser in the air and running. Also can hear a slight roaring noise from front diff center section. I really didn't want to have to regear at this point because it isn't lifted yet or bigger tires of course, and I was planning in a couple of months to just do the medium spring with 295's and stock gears due to fitting it in the garage and being my daily driver and cost issues of course. My friend has a front set of 4.88's gears slightly used from his hi-pinoin chunk due to he upgraded to 5.29's so that will save me some money there. Anyway who do you recommend getting the rebuild kits from and how much should I expect to pay for one of these with all bearing and seals front and rear. Since I'm not ready to spend 3 bills on lift and tires and gears I might just try to rebuild now. I'm ready for everybody's input, bring it on!:cheers:
 
$300?

I think Marlin crawler sells diff rebild kits. Other than that, I'm not much help.
 
Brother Brian lost a pinion bearing on his rear diff. He got the pinion bearings, crush sleeve and seal from Kurt @ Cruiser Outfitters ~$50? Pretty easy job to replace them if you have access to a press, dial gauge and inch lb beam type torque wrench. His would howl at high speed only when warmed up.
 
Thanks Kevin, that sounds just like mine too. After driving a little while on the hwy you can hear a repetitve roaring noise at 75mph and up. I think I will just try to rebuild it for now.​
 
He pulled the diff and brought it to my place, it turned and felt good until we pulled the carrier and spun the pinion, it grumbled just spinning by hand. We took the pinion out and put the carrier back in and it sounded good. We just replaced the pinion bearings and all is good.

Is yours locked? The procedure is slightly different between locked and unlocked.

Some good reading on diff setup;

http://www.gearinstalls.com/
 
Back
Top Bottom