Diff Armour/Skid?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 24, 2006
Threads
63
Messages
666
Location
Abbotsford BC
I searched briefly and found nothing 80 series specific. I may make something myself, but would rather just weld something pre made on.

Problem is I have bashed the underside of my front diff so bad I can't get the drain plug out and somehow even broken the seal of the third and was leaking gear oil. This may have been from loose bolts I was un aware of and getting it hooked on a rock because all the lower bolts were extremely loose. BTW anyone know the proper torque specs for those cause I busted a stud tightening them.

Anybody know of anything or have any pics of custom stuff?
 
I searched briefly and found nothing 80 series specific. I may make something myself, but would rather just weld something pre made on.

Problem is I have bashed the underside of my front diff so bad I can't get the drain plug out and somehow even broken the seal of the third and was leaking gear oil. This may have been from loose bolts I was un aware of and getting it hooked on a rock because all the lower bolts were extremely loose. BTW anyone know the proper torque specs for those cause I busted a stud tightening them.

Anybody know of anything or have any pics of custom stuff?

The 80 front diff is 8", same as the mini, so Marlin, Trail-Gear, etc. Also if you want to fab. the 8" pipe cap trick works.
 
Thanks for the info.:) I think I'll get one of these (fourth down page) http://www.trail-gear.com/trail-armor.html even comes with low pro plugs. I would do the pipe trick if it wasn't so cost effective. Haven't had too much trouble with the rear yet, but anyone done anything to it or seen anything?:beer:

how do you weld something like that? drain oil, clean well?
 
I think I would keep the oil in to help dissipate the heat, let cool, then change it and like any weld the cleaner the better.:cool:

sorry, I meant clean the inside. I guess I can see 2 ways: very clean or still filled. But the latter could result in a fire maybe?

and aren't there seals very close to the diff?
 
sorry, I meant clean the inside. I guess I can see 2 ways: very clean or still filled. But the latter could result in a fire maybe?

and aren't there seals very close to the diff?


I don't see why you'd have to clean inside the diff? I would change the fluids just to be anal, but you probably don't need to. If you just stitch it on, go slow and allow time to cool everything will be fine. My brother in laws spider/side gears were welded without removing the carrier and it's fine.:beer:
 
sorry, I meant clean the inside. I guess I can see 2 ways: very clean or still filled. But the latter could result in a fire maybe?

and aren't there seals very close to the diff?

The closest seal is the pinion, if you get it hot enough to damage it your doing something wrong!:eek::D
 
Back
Top Bottom