Did I Overfil Knuckle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2008
Threads
31
Messages
365
Location
Longmont, CO
I've seen threads on this topic but what just happened to me might be a little different. I pulled the plug and stuck the end of the hose (from the grease gun) into the knuckle and started pumping. Got a couple dozen pumps in and pulled the hose and grease actually oozed out.

Damn. So I've seen where people have asserted that the grease layers in there so you really can't overfill. Is that still the case if it oozed out?

Thanks,
Paul
 
Grease is thick and it blogs up without filling the chamber. Drive it around fro a while, remove the plug, stick a small screwdriver in to use as a dipstick. You want the cavity to be 1/2-3/4 full.

I've seen threads on this topic but what just happened to me might be a little different. I pulled the plug and stuck the end of the hose (from the grease gun) into the knuckle and started pumping. Got a couple dozen pumps in and pulled the hose and grease actually oozed out.

Damn. So I've seen where people have asserted that the grease layers in there so you really can't overfill. Is that still the case if it oozed out?

Thanks,
Paul
 
Yes it can be overfilled, but it doesn't sound like you did? When grease is pumped in, air needs to come out the same hole, it sounds like air pushed the grease out. Did you check the level before filling? I turn the steering all the way to the side I'm working on, then can see into the knuckle chamber, getting a better idea of the level. It's also easier to put the grease in, doesn't get backed up by the hole. If it looks low I don't try to completely fill in one shot, put some in, drive a week or so check/fill, repeat, it's easier to add more, than remove excessive grease.:hillbilly:
 
I don't see how these can be "overfilled" as in the latter causing damage. If anything, it's hard to fill them enough in my experience.
 
You can spin the wheel after a few pumps, then repeat. Spin, pump, spin, pump(that just sounds wrong), until you have the right amount in.

turning the wheel outward is good advice. It makes it much easier!
 
I don't see how these can be "overfilled" as in the latter causing damage. If anything, it's hard to fill them enough in my experience.

I have seen/repaired at least two that were pumped full by shops. Makes a huge mess, the heat from running pushes grease into the axle and wheel bearings. In both cases the wheel bearings were full of moly and flinging out of the hub seal.:frown:
 
I have seen/repaired at least two that were pumped full by shops. Makes a huge mess, the heat from running pushes grease into the axle and wheel bearings. In both cases the wheel bearings were full of moly and flinging out of the hub seal.:frown:


that's just either the built-in "full" indicator or the automatic level adjuster...:)
 
Lots of good feedback here, thanks. I got up yesterday morning and took it for a spin and checked the level as suggested. As most predicted, the side that "oozed" when I pull the grease hose was only about 1/2 full. So yeah, it did kind of pile up like a soft-serve cone.

Now I did turn the wheel all the way depending on what side I was checking but I couldn't "look" inside. I did run a thin screwdriver down there and it was almost exactly half. I also found it interesting that the grease was still the same color (good) but also that the grease definitely gets more fluid after having been "stirred around" in there.
 
Back
Top Bottom