dash lights flashing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

semlin

curmudgeon
Mod Emeritus
Joined
Mar 27, 2003
Threads
332
Messages
5,236
Location
north of 49
Coming in this morning when idling in traffic I got the AT/oil/brake/alt gauge red light and possibly the CEL charge lights flashing on momentarily twice. Not 100% sure as it was just for a second but definitely not all the dash lights. When I tested the ignition on it seemed like more lights came on for that than what I got.

is this combo maybe a low charge signal or could it be the starter sticking? I didn't hear the starter engaging and it was 10 minutes into the commute before it happened.

also, if it is the alt, could a slipping belt cause it? my belts are 30k old so they need replacing but i'd sooner pull the alternator at the same time if that is the issue.

My alternator got new brushes last spring and has not gotten muddy lately. it was been driven in heavy rain last time it ran but no puddles. I'll check the belts tonight before I go home.
 
hmm, no answers huh? I guess i mostly answered my own question.

well the belts seem fine. it did it again today at the same point in the drive. also, at idle the voltmeter is noticably bouncing in time with the indicators but this stops as soon as it gets gas. voltmeter shows it is charging normally or maybe higher than usual. i'm going to check the water in the battery.
 
check your cables / terminals
 
i will check the charge level when not running before i start it tonight. it was fine when i checked after arriving.

just remembered jump starting a guy on friday with a dead battery. used truck once after that before the trouble started.
 
ok this is back with a vengeance. can folks tell me if i have an alternator or ecu problem or a bad battery cell or what? I'm assuming alternator is bad but read on.

today, dash light flashing started. exactly the same combo as before. happens under hard breaking as rpm dies.

but here's the weird part. after i stopped and shut it down the truck turned over just fine but would not start. I tried several times. good crank, no battery fade but no spark. I tried my spare efi relay and it made no difference. after about 30 minutes with the hood open it finally caught but it would only idle at 400 rpm and all the dash lights were stuck on and the alternator was flat. I revved it up to 2000 rpm and the lights went off and did not come on again and I limped it home and by the time i got there 45 minutes later it would still only idle at 500 rpm. the alternator did bounce up from the middle at rpm but looks to be charging a little less than usual. it will start easily but still onyl 400 rpm idle.

i checked and there are no cel codes

when i turn on the indicators the alternator needle bounces in time.

and oh yes, i forgot my fsm at the cabin in all the excitement so it is 45 minutes away :doh:
 
My guess: You fried your alternator when jumping the other day. No good deed goes unpunished.

Was the jumpee's car DEAD or just needing a boost?

Dave
 
Start with the known problems and work your way from there....

My suggestion would be get that alternator out of the engine and have it bech tested at a local parts store (advance, ect..) most likely it will be bad... My guess is there is/was a voltage issue when you jump started the poor guy (hopefully you didn't do a straight positive to positive, negative to negative because thats when things go bad.. should be positive positive, negative, ground...) and stressed the alternator to the point of failure.

You can follow the FSM and diagnose each individual component on the alternator and order what you need from CDan... (good option if you have a 1FZ only though)

I'm currently rebuilding my alternator entirely and will be posting a writeup once i get my parts from Cdan (thanks again Cdan)

If you don't feel up for that just order a new one from American Toyota or wherever your favorite parts store is....

Once you get that problem solved... see if you still have lights blinking at you... if you still do, then at least one problem is solved and you are pinpointing it down...

Worst case senario, alternator put out too much voltage and fried something... i just hope nothing like that happend...
 
he left the lights on.

but note the 3.5 month gap between these incidents. i also just noticed a heavy rain just beforehand common denominator. it rained like crazy last weekend and the car has only done a few miles since until today.
 
As a matter of fact, you should test the battery while the alternator is out ;)

Just so you know, alot of the dash lights coming up is almost always related to the alternator...

But the poblem you described about the no-start situation could be related to something else, but like i said start with the known, and work your way from there...




I forgot to add, if it is the alternator that is causing this, i would remove it ASAP. Voltage spikes can be really bad on electrical components...
 
Oh and i almost forgot to add...

Check all cables, and grounds....

Make sure there is nothing loose or corroded, I almost overlooked the simple but common problems....

Bad grounds or connectors could cause states of low charging
 
thanks, I will check over the grounds carefully and see if I can get the battery load tested.

the no start problem has never ever happened before. heck of a coincidence to happen immediately after the flashing light issue came on like gangbusters.
 
You don't by any chance have the ECU that was defective and replaced do you? The way you describe it's running, it sounds like limp home mode in the ECU. Not sure if the 93 ECU has a limp home mode.
 
You don't by any chance have the ECU that was defective and replaced do you? The way you describe it's running, it sounds like limp home mode in the ECU. Not sure if the 93 ECU has a limp home mode.

yup that is what confused me. why did it crank hard but not start and why did it run at 400 rpm. i understand i am getting alternator erros issues but is this alternator stuff?
 
It could be an ecu issue...

But i was just suggesting you try to eliminate the known problems...
If swapping the ecu is an easier option, then i would go for it

Although, if your alternator is throwing out voltage spikes, which is what im guessing happend here, and fried your ecu, swapping in the new one and having the same problem happen again is not a good idea...
 
If you have a strong battery the engine will run normally with a dead alternator until the battery drains. So in my mind as long as your battery is strong that SHOULD eliminate the alternator as the cause of the poor running condition. Of course, alternator failure could have caused the poor running condition....
 
update: I cleaned the ground connections and reattached and so far it is running normally.
 
Semlin,

Some time ago I got in the habit of putting silicone grease on any electrical contact I touch - it keeps dirt out and prevents corrosion. I dont anything about the Toyota charging system, but in the GM system I seem to recall that the ecu depends on the alternator for engine speed, and partly for ecu timing. These are just recollections though.

Karl
 
Back
Top Bottom