Cylinders 5 and 6

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 1, 2014
Threads
18
Messages
158
Location
Winona, Mississippi
So, we have a misfire on cylinders 5 and 6. We changed injectors, checked for ECU signal, replaced plugs and still have misfire cylinders 5 and 6. Going to check for compression tomorrow. I have searched forum for ideas and have not found any ideas. Cylinders 1-4 are fine. Cylinders 5 and 6 just quit at the same time.

thoughts?
 
Wiring harness at the EGR or blown head gasket.
 
Second the vote to inspect the wiring harness at EGR pipe. Common culprit and those are the most affected injectors. While you are there, I would also inspect where the individual wires for 5 and 6 inj exit the main loom. The bend as well as the base of the plug have been problem areas for folks before. Also use caution they don’t get swapped as the lengths will allow 5 to plug into 6 and vice versa. Red/gray/red alternating injector colors for a quick reference.
 
Back
Top Bottom