cylinder hone

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 15, 2005
Threads
322
Messages
3,082
Location
on stage
Website
www.barryhause.com
On my original thread about the headgasket replacement someone mentioned something about doing an in-frame rebuild of the cylinders and ring replacement. I've searched and haven't found much detailed info on this.

Anyone care to enlighten me on the process of honing cylinders, necessary tools, cleanup? I'm trying to do as much as I can without actually pulling the engine. In otherwords, what I do needs to take place in my driveway but I want to do as much as I can so as to improve chances that this will hold for a while.

Thanks again for all the input.
 
Might want to post this in Tech, not parts wanted
Basically, if your cylinder walls have minimal wear and your bearings are all up to spec, you might get by with a re-ring, may need new pistons, another thing to consider is wrist pin wear. Cylinder wear can first be determined by a big ring ridge and original hone marks being visible. I have never seen a f/2f block with much of a ridge. Definitely get a manual if you don't have one. I did a "refresh" on my ol' f engine many moons ago and it is still going, 90 to 120 lbs. compression isn't very impressive tho'.
 
Back
Top Bottom