Cutting rocker panels for sliders?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 28, 2006
Threads
20
Messages
165
Location
Bend, OR
I'm looking for insight on possibly cutting bottom of rocker panels out to accomedate for some homebrew sliders. My truck has some serious dents on the rockers right now. Looking to gain some clearance if possible?

Anybody see any problems with this?

I've done it before on an FJ60 due to rust and it turned out great. Not sure about the 80 though? drainage in to the rockers? Trying to cover my bases before the sawsal comes out...
 
I did it to my 62 because of rust as well...and if I had to do it over again, I wouldn;t. I welded 2x4 in the rockers place, but I had to tie it to the frame to be ableto support the weight of the truck, or it just kept pushing into the body. Tie the body to the frame like that, you need a bushing in there somewhere so you don;t start tearing the body. (solid mounted body at the rockers and on bushings at the body mounts)
With an 80 being even heavier, it would be that much worse. I'd just do sliders welded to the frame, and forget about the dents.
 
It seems to me that the sheet metal is a structural component, a boxed section, and you would need to replace that component if you cut it away or risk tweaking the body. I've been thinking for years about cutting the rockers out and replacing them with some box steel to use as sliders. The difference is that the forces of hitting a rock or whatever would be transferred through the body mounts to the frame rather than the other way around. I think it would be fine, but there are people who think otherwise. There have been a few threads discussing this, if you want to look for them.

-Spike
 
I recall Lowenbrau doing that on a 70 series. He replaced the rocker with a section of pipe. It looked really good, and at a glance you couldn't even tell it had been modified.
The drainage might be an issue though. I recently installed some bolt on sliders that a fellow mudder made up, pics in the 'custom hdj81 sliders' thread. Some gray primer and those hide my single rocker dent quite nicely :)
 
Jeff Jones did that on the white whale. Probably circa 1998. His stuff is documented here, but not sure there are any details on the sliders. If memory serves me right Eric Holleman did that as well. This was BM (Before Mud)

Other Projects and Interests

For the young ones around here, search http://www.birfield.com/archives/html/80scool/ for sliders and see some old discussions.
 
Last edited:
I think you could just go with some thinner stuff under and then rap it up the side some to hide the dents.
 
the dents don't bother me. It's getting some ground clearance that I'm after.

My idea was to cut out the bottom portion and fab up some welded sliders to the frame, not the body.

The way the truck is now, I guess I could take the BFH and pound them up as well?
 
just a follow up post. Decided cutting and boxing the rockers was going to be more hassel than it's worth. Maybe when resources and time are better, I'll give it a shot.

Pics of the recent steel addition
100_0241.webp
100_0242.webp
 
Back
Top Bottom