Custom Slee sliders *PICS*

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 16, 2007
Threads
41
Messages
615
Location
Portland, OR
I had a set of slee sliders lying around the shop...so I decided to put them on my fj80. Come to find out slee doesn't make sliders for an fj80....they only make them for fzj80's. I thought to myself....hmmm, do I want to cut these perfectly good sliders up to make them fit my 80? My decision was yes.

The procedure was quite simple. All I need to do was to move the front arm back about 6 inches on the driver side slider. Everything else bolts right up.

So I plasma cut the leg off and then lined both sliders up together. The leg from the passenger slider gave me a good idea of where I want the new leg of the driver slider to go.
IMG_0557.webp
IMG_0558.webp
IMG_0559.webp
 
Before I went any further, I looked ahead to where the sliders were gonna be mounted on the frame and saw the the hard brake lines were gonna be in the way of the u shaped bolts that wrap around the frame. So, I unbolted them and planned on placing the u bolt underneath the lines and then bolting them back to the frame with spacers under the lines.

The third picture shows the leg partially welded up to the new spot on the frame. It was easy to find the angle to cut the leg and attach it to the slider because I clamped it to the other slider.
IMG_0560.webp
IMG_0561.webp
IMG_0562.webp
 
Sorry about how dirty the sliders look...I didn't clean them off at all before I started. It was late I did it on a whim. Back to the action.....

....here are a few shots of the MIG weld that was made. If I remember correctly the legs are 3/16 and I did the welding for this project with my 110v. I got full penetration.
IMG_0563.webp
IMG_0564.webp
IMG_0566.webp
 
The first pic shows the hard lines that I was talking about earlier and the u bolt going underneath them. The second shows a plate that I ended up putting under that new leg of the slider to make it sit flush with the frame. The weld look like a booger I know, but it was late and I just needed it hold the plate in place.
IMG_0568.webp
IMG_0569.webp
 
My two other pics of the finished product wouldn't upload for some reason, but I'll take some more tonight when I go to the shop. It turned out well and I am pleased with the result. I am driving around with them for a week to let them settle and then I'll tighten the bolts again and tack weld the legs to the frame so they don't slide around.
 
nice approach.

Interesting that there are gussets at the frame mounts, but not at the main slider rail. You sure the latter weld will be strong enough without gussets?
 
nice approach.

Interesting that there are gussets at the frame mounts, but not at the main slider rail. You sure the latter weld will be strong enough without gussets?

Thats the way they came from slee; mine have no gussets at the outrigger/slider connection. Plus the gusset at the frame rail resists upward forces of the slider from impacts, and at the slider rail there would only be room to put horizontal gussets, and not vertical. However i am basing this on the stepsliders, but those look similar in construction and size.

Nothing like improvizing BOO.... awesome work and thinking.
 
Back
Top Bottom