Crums' Custom Welding Sliders

[Lovey]

Thanks to cruiserhead for fabbing these up. They look great and I'm sure will
take some good abuse. Nice work as always.

tech: 2x2 3/16th for the main section. .120 wall 1.5 inch tube. .25 inch frame tabs. Bolts up to the factory holes.

 

[Gibbs]

Those are sweet. I saw a set first hand in April at our FJNE Run.

 

[Twidget]

Dave does good work. I also saw these at the Easter run.

 

[niceguysanti]

I'm hoping that I finish my 62 during this lifetime so I can get it out to Dave for some sliders and a rear bumper.

 

[NCFJ]

I've seen Dave's work, he does nice work.

I'm hoping that I finish my 62 during this lifetime so I can get it out to Dave for some sliders and a rear bumper.

I know how you feel, I am a bit behind you. Some of the steel for the Truggy frame will be here tomorrow.

Stan

 

[cruiserhead]

Thanks guys.If it wasn`t for Lovey lending me his truck for measurements I would not have been able to make them.

David

 

[lucasfj60]

give me a better pic of that weld did ya slpatter gun it

 

[cruiserhead]

All joints are Mig welded.I`ll Tig weld up a set for you but it`ll be more than $400.

David

 

[MoabFJ]

Nice length on those. Too many sliders are like the stockers, not enough protrusion to offer much protection.
Plus, try to get a high lift under the stubby versions without creasing your door.

 

[NBFJCruz]

I also saw a set at the Northeaster Run and was super impressed.

 

[land cruiser kid]

Crum's welding

David's a good guy, I've seen his work in person at the coal miner, he does nice work! Steve