So I was driving about 55 mph when my cruiser just died and rolled to a stop. I checked the basics with fuse box inside and under the hood. Everything looked good. I then searched mud and found my problem, well one of them. It was the main fuseable link before the 15 amp EFI fuse. The wire looked good but no continuity. When I cut into it I could see the copper wire fused together and separated. Thanks to the participants on the board who post here I fixed it. I am new to working on EFI and it would have taken me much longer than the 15 minutes it took to figure it out by myself. Use the FAQ and search, they are your friend. Now it looks like I probably need a new wiring harness, as I am thinking this is what caused the problem to begin with.
Thanks again.

Thanks again.