Cruiser Lean

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 12, 2005
Threads
7
Messages
68
I am going to put my new HFS 4" susp on my 40 this weekend and have found that I need a Shim to correct the lean. Does anyone have the dimensions of a shim? Thanks very much in advance!! :) :beer:
 
I saw that

It's kinda vauge though "4 or 5 inches long, 8/8 thick or so" thanks for the link. I am hoping to find someone with measurements of an actual shim that works. I'd buy one but this is going in tomorrow and I can build one at work in about 20 min. Thanks again.
 
When I bought my very first FJ-40 back in 1992, I also picked up the Brooklands Book that is shown in that link. Let me assure you that if you go to a Toyota dealer, you can order the part number that is listed in that article. I bought mine from the dealer and installed the shim and the result was no more lean. That was back in '93; however, I feel certain that they can still order it for you. It was NOT very pricey as I recall. Good luck!
 
Boberino said:
It's kinda vauge though "4 or 5 inches long, 8/8 thick or so" thanks for the link. I am hoping to find someone with measurements of an actual shim that works. I'd buy one but this is going in tomorrow and I can build one at work in about 20 min. Thanks again.

IIRC it was about 3/8" thick, the correction you get is twice that, I think. Since you can make them, I'd make 2-3 thicknesses and mill a "U" un one side so you can slip it in after loosening the U bolts, in case you don't get the first one right. That's how a lot of caster correction shims are made.
I'll try to attach a pic of a CC shim I found in my old axle.

GL

Ed
springswap 007.webp
 
The nice thing about the factory piece is that it has the centering pin on it. If you use one of the caster correction shims, you better buy and install a lengthened centering pin.
 
I just ordered the CCOT leveling block on tuesday. Nolen put one on his family hauler that leaned just as bad, if not worse than mine. It leveled it out, so i'm convinced. It's a 3/8 piece of steel the same width as the spring and as long as the spring perch with a hole in the middle, and a center pin. I could've made one too, but i'm not buying a length of 3/8 flat stock just for a 4-5 inch piece.
 
I second it. My cruiser w/ HFS 4" leaned and put the CCoT leveler block on and bingo, no lean. Looks absolutely level!
 
Back
Top Bottom