crossover/high steer

[thrashattack]

i was thing about going high steer but i was wondering if my 3inch lift would be a problem? if so does any one sell or made a normal cross over steering? whats the parts list

 

[liljlandon]

Its been done with a 3" lift. You might have to lengthen one bump stop to prevent thrashing your frame/ highsteer kit.

As for Cross over, It has also been done. Youll need an IFS steering box, hoses, draglink, pitman arm, and the one side arm. They have been made before, luke at 4x4labs might make one... Im not sure. There is a thread a few pages back that has a guy running crossover.

 

[cavemancaleb]

ifs steering bax and fj62 steering arms with adjusted fj62 steering links and ends. Poor mans crossover that should work for minimal lift. wouldnt be highsteer but it would be cross over.

 

[Mike C]

Plenty of people doing high steer with a 3 inch lift up front. Look at all the builds with RUF packs. Just need to make sure you rotate your box up enough to get the drag link close to the frame.

 

[sparticus]

I always thought you needed 4 to 5 inches of lift, but that all dependes on the position of your steering box, high steer is expensive though and if all you need is the cossover, then i would go with the fj62 arms and links, Datinfab has the cheapest links if you want new ones

 

[cruiser88]

what rig do you have?

 

[ntsqd]

What I went through to do this:
https://forum.ih8mud.com/79-95-toyota-truck-tech/270775-cross-over-3-lift.html
This is an original LA truck on OME 'Heavy' front springs.