Crazy Idling with A/C on

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 15, 2008
Threads
4
Messages
41
Location
North Carolina
I have searched and searched for a solution to this problem but came up empty handed. I have had this problem for the past 2 summers with my air conditioning. When I turn my air conditioning on it jumps up to say 1200 rpm's (which I know is normal) and then settles down to 800 rpm's. However, once it has been on for a few minutes and the compressor shuts off my rpm's drop all of a sudden to 350-400 and then jump back up to 1000-1100. The only thing that worries me about this is when I am sitting at a red light and my compressor shuts off I have to be very careful that my foot is firmly on the brake or I will bump the person in front of me when the compressor engages and shoots my rpms back up to 1000-1100. My rpms continue on this roller coaster like pattern of going up and down until I get to an open road and I am not in stop n go traffic. When Im in stop n go traffic it continues nonstop.
Almost forgot my truck is a 94 with 108000 mi. system was recently charged so it is cold but it just worries me with the compressor clicking on and off so much. Any help would be greatly appreciated.
 
My idle kicks up too which I guess is normal like you said. Rest doesn't sound right. Sorry I have no answers, but rather an additional rant.

It kills me that on my other smaller engine vehicles; 01 Honda and 05 WRX, they do just fine when the A/C kicks on. And my huge I6 LC jumps up as if it can't handle the additional drag.

rant off :D Good luck...
 
I have the same idle up-n-down but rpm only goes up to 800rpm when the AC is on. Sometimes when I'm at a stoplight, rpm goes down a little lower than 600rpm and then goes back up to 800rpm. It did worried me at first since but somebody here said, it's normal. I don't know about rpm going over 1200 with the AC on.
 
I had similar issues with my idle both with the AC on and off. I did the o-ring fix on the IAC which would help a little, but didn't solve the issue completely. Last week I pulled the throttle body and cleaned 14 years of gunk out of it. I also replaced all the vacuum lines.

Bottom line...Truck runs great now. Idle no longer fluctuates erractically and the start up idle is right where it should be.
DSCF0240.webp
DSCF0241.webp
 
Guys thanks for the feedback I think I will try the route gotmud used. However, I am not too familiar with the cleaning of a throttle body. Is this something that should be taken to a dealership (which I really want to avoid) or could your local shop take care of this?? What would be a fair estimate to replace he vacuum hoses and clean the throttle body. Also could my MAF sensor be playing a role in this erratice idling? There are no visible cracks in the MAF but I guess there could always be some that are very small and nonvisible.
 
This a :banana:job at the most. Its also a $ job. Removing the TB requires removing 4 bolts and a few lines. Nothing major at all.

I used two cans of TB cleaner. Don't forget to replace the gasket. There are a couple of write ups here on MUD that go into more detail. PM me for the FSM instructions.

Kerry
 
Back
Top Bottom