Crank shaft seal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 4, 2003
Threads
20
Messages
75
I am puttng in a new crank shaft seal in the timing cover plate on my '77 2f- is the seal supposed to sit flush with the timing gear cover or does it stick out? I dont want to damage the seal by forcing it in but I dont want it to leak again because I wasnt paying attention when I took the old seal out.
Thanks
 
You have a little room to play with there. I left mine out about 1/8 in from being flush to compensate for the old seal's groove and lack of speedi sleeve. As long as you're not hitting the pulley you'll be fine. Or you could put it flush and be fine that way too.
 
Back
Top Bottom