Could someone help me?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 3, 2005
Threads
8
Messages
21
Location
Laurens
I own a stock 1976 FJ40. I am looking to purchase the Rough Country suspension lift at 4". I have never installed a lift kit but I feel confident about the kit. Now my question...The lift kit is pretty straight forward. What else will need replaced? Does the driveshafts have to be doctored and what about the pitman arm? Are there additional parts that are recommended to replace? All information will be helpful and appreciated.
 
You shouldn't have to alter the drivelines but maybe the two brake lines that go from frame to axle should be changed. If you do that, save yourself much grief and buy the kit frim SOR rather than going elsewhere and getting the wrong lines.
Do yourself and your vehicle a favor by buying new pins for the non-shackle ends of all four springs. Again, I recommend biting the cost bullet with SOR - at least they get it right if you give them correct info about your vehicle.
Nothing about the pitman arm operation will change, The drag link has plenty of movement to take the change you'll make.
Have fun!

editted to add: if you use the search function here you should be able to find floods of info about every facet of the nasty thing you're about to do. :)
 
Welcome.


You may need to lengthen, or change where your brake hoses that route to the axles attach to the frame, or install longer ones, depending on the amount of travel that you end up with this kit. Your driveshafts *should* not need any modifications, but searching out here under, say, 4" lift, will probably give you a lot of things to read through, as this has been discussed out here to great lenght.


Good luck!


-Steve
 
Yo Steve! Better late than never! :D
 
Its easy and very basic, unlike those HEEPS. its a total of around 44 bolts and your done. It took me around 2 hours to do, and only had a problem with one of the springhangers, and had to drill out the stock plate that the U-Bolt goes through. I installed a SkyJacker on mine, I dont know is its any different than yours, but if you have mechanical experience its cake.
 
Sick. To lift cruisers is sick. :)
 
YJs and CJs are basicaly the same, but we had a couple problems with 2 TJ's. one problem was the Trac- Bars didnt line up, and getting to the front coils on the top. and another friend with a TJ had to cut his floor for some reason ( wasnt there) to remove the kit. You also need to do a pitman arm ( which didnt want to come off on one of them) They arent that much harder but i wouldnt say easier. it took my one friend around 4 hours to put it in.
 
also you got to adjust the 8 control arms. sorry I forgot about those lol
 
you will need the correction shems for the front axle. The shems correct the pinoin angle.
 
Bodean said:
you will need the correction shems for the front axle. The shems correct the pinoin angle.



Ahhhh...no they make pinion angle worse, but do correct the caster, They point the pinion down when installed to correct caster, which is why they're called "caster correction" shims, not pinion angle shims. If you install them backwards, they will point the pinion up, but greatly f'up your caster leading to bad handling and even "death wobble".


Ed
 
Sorry, I should have known that. I don't know what I was thinking.
 
Back
Top Bottom